Conseils de pose
> Pour la mise en œuvre des papiers-peints
+ d'infos> Préparation des fonds : le mur doit être propre, sec, lisse…
+ d'infos> Encollage Papier-Peint : L’encollage varie selon le type de revêtement choisi …
+ d'infos> Pose Papier : Poser trois lés pour valider la conformité du produit…
+ d'infos> Notice de pose Stickers - 1 : La surface sur laquelle vous appliquez le sticker (mur, plafond, porte, meuble, fenêtre, miroir par exemple) doit être sèche, propre et lisse…
+ d'infosApplication Instructions Stickers - 1
Application
The surface on which you are applying the sticker, for example a door, wall, or piece of furniture, must be clean, dry and relatively smooth. Blot with an appropriate product if necessary. A smooth duplex or vinyl wallpaper surface would be ideal.
Remove the protective paper backing.
Apply the sticker to the surface and rub it with a clean cloth applying pressure to remove the air bubbles.
Remove the protective transparent film if there is one.
The position of the sticker can not be changed once it has been applied.
Special instructions
It is possible that the sticker will not adhere fully to a highly textured vinyl wallpaper with a sheen.
If this is the case, blot the surface on which the sticker is to be applied with a cloth dampened with methylated spirits, allow to dry and then apply the sticker. Methylated spirits does not damage vinyl wallpaper.
The sticker must not be cleaned with a solvant.
To permanently remove the sticker, heat it with a hair-dryer.
Not suitable for children under the age of 3 years old.
Do not stick near to a source of heat.
The surface on which you are applying the sticker, for example a door, wall, or piece of furniture, must be clean, dry and relatively smooth. Blot with an appropriate product if necessary. A smooth duplex or vinyl wallpaper surface would be ideal.
Remove the protective paper backing.
Apply the sticker to the surface and rub it with a clean cloth applying pressure to remove the air bubbles.
Remove the protective transparent film if there is one.
The position of the sticker can not be changed once it has been applied.
Special instructions
It is possible that the sticker will not adhere fully to a highly textured vinyl wallpaper with a sheen.
If this is the case, blot the surface on which the sticker is to be applied with a cloth dampened with methylated spirits, allow to dry and then apply the sticker. Methylated spirits does not damage vinyl wallpaper.
The sticker must not be cleaned with a solvant.
To permanently remove the sticker, heat it with a hair-dryer.
Not suitable for children under the age of 3 years old.
Do not stick near to a source of heat.
